Power Distribution Center (PDC 90)

Designed to fuse and distribute power to various devices normally found in an emergency vehicle, PDC 90 provides a convenient way to distribute switched power (applied only when ignition key is turned on) and direct power from the battery.

                Power Distribution Center (PDC 4)                    

PDC 4 relay control board has similar PCB as non-MUX version but uses digital multiplexing to receive encoded address signal for each relay coil. Minimizes wiring harness.

4 Position Relay Control

4-position relay control board has four 40 or 30 amp relays, removable input terminal connector, and output terminal connector. Diagnostic LEDs provided for each circuit. All relay coils are ground-enabled. Inputs have diode protection.

Power Distribution Center (PDC)

Controls up to 10 outputs, 160 amps total rating. Relay Control board has 10 relays rated up to 30 or 40 amps and an input connector. Relay has selectable triggers for relay coils and two end relays have common input

.